Boss PX01 Incab Air Kit

Description

No electronic valves here!

Designed to Inflate/Deflate (two) airbags without the need for a tank

The airbags are inflated by our super reliable PX01 compressor via a momentary toggle switch

To deflate there are two pneumatic ‘dump valves’ at the control panel

The pressure either side is represented on the dual needle analog gauge

Activate the compressor with the toggle switch to air Up, and dump air either side individually by depressing the pneumatic valves….it’s as simple as that

How much air do you put in the bags?

Typically, when you weight load your vehicle the back will sag down (which is probably why you already have a Load Assist Kit)

To find the perfect pressure where your vehicle will handle its best, introduce sufficient air to bring it level again……so pressure required will be subject to the weight being carried

With this kit you can run different pressures either side which is handy to level out when parked on slopes or carrying vastly uneven loads

INSTALLATION

This analog kit is predominately about plumbing

The compact oilless compressor is best installed in a dry & well ventilated area, under the bonnet is perfect and power can be easily sourced

Air line is run from the compressor to a check valve where it splits off to individual sides. It is then run through a series of quality push fittings and into the cab where the gauge / instrument panel is (typically) mounted. Two lines then continue to the back where they simply ‘T’ into the load assist kit between the airbags and the Schrader valves

This Incab Control Kit comes with all componentry required for installation including concise instructions and a simplistic diagram